-
How to reinstall firmware for ABB IRC5 FlexPendant
Sometimes when the firmware is corrupted or there is a fault with the circuit board, the FlexPendant gets stuck at the booting screen with no graphic or control but just a black screen. Before sending the FlexPendant to repair or purchasing a new one, one can try to force the FlexPendant to download and install…
-
How to set up Profinet connection between an ABB IRC5 controller and a Siemens PLC
ABB IRC5 controller can be set up as a basic IO device for a Siemens PLC over Profinet. The PLC then will act as a master, reading and writing various types of data to robot controller. To use Profinet communication for IRC5, the option 888-2 PROFINET Controller/Device must be purchased from ABB and installed. The…
-
How to create a new system in ABB S4C+ controller with RobInstall
The TCP/IPv4 properties of the Ethernet adapter of the used computer needs to be set as following. IP: 192.168.125.82 Subnet mask: 255.255.255.240 Default gateway: 192.168.125.81 Connect the computer Ethernet port to the service port on the front of the controller via a straight through cable. The creation of a new system requires either a backup…
-
How to activate/deactivate a mechanical unit within an ABB IRC5 robot controller
A mechanical unit can be either a robot, usually 4 or 6-axis, or an external axis, for example, a rotational tool holder or a linear slide. An IRC5 controller cabinet usually has a single drive unit to control up to 6 axes of a robot plus three additional drives. Its computer can be interfaced with…